I have discover that if I disable IPv6 then get a valid IP. And also I have
been trying make a connection by ethernet with the same results. But in this
case if I disabled the IPv6, the ethernet interface get IP but don't works
dns resolutions.
Any suggestion?
"Robert L [MVP - Networking]" wrote:
> The link should work. Also the Microsoft has a update for fixing the Vista wireless issues.
>
> Bob Lin, MS-MVP, MCSE & CNE
> Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
> How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
> "Robert L [MVP - Networking]" <noreply@hotmail.com> wrote in message news:ONz3r071HHA.5980@TK2MSFTNGP04.phx.gbl...
> Many possible causes. I would check the NIC driver and router firmware first. Or this link may help,
>
> Vista Wireless Issues Vista: Common Problems with 802.11 Wireless ... Inability to Connect and the wireless doesn’t receive the single. 1) It could be the Wireless adapter driver ...
> http://www.wifimvp.com/vistawireless.htm
>
>
> Bob Lin, MS-MVP, MCSE & CNE
> Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
> How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
> "Santiago Merino" <SantiagoMerino@discussions.microsoft.com> wrote in message news:A2DD2E00-1123-4BD9-BAF0-365DD70A98AE@microsoft.com...
> I had normally my WLAN profile configured fine, but after a bad shutdown. My
> computer, now never get a valid IP, only if I configure a valid IP the
> connection works. I have been checking my router but it's ok.
>
> Where is the problem?