Hello StephenB,
I use Windows Vista Ultimate X64 SP1 (build 6001.18000) and my time format
in Control Panel is set to HH:mm:ss. I use "English" Windows Vista Ultimate
with Slovenian regional settings applied. These settings were applied at
installation of Vista, prior to installation of OneCare 2.0. Unfortunately I
don't have other computers running Vista X86 or XP.
Best regards,
Mitja Harej
"StephenB" <sboots@xxxxxx> wrote in message
news:l660r3t0eu8ms3vg83cmi68sc4v9b1281r@xxxxxx
| Quote: |  | |
|
> You specifically mention Vista X64. Have you compared the dialog in Vista
> 32 bit
> or XP?
> On a Vista 32 bit laptop, I'm looking at the dialog for the time and it is
> based
> on a 12 hour clock with an AM/PM selection.
> In Control Panel, Regional Settings - is your time format:
> HH:mm:ss tt
> or
> HH:mm:ss - without the "tt" which is the AM/PM designation.
> I switched my time setting to be the 24 hour clock and I still see AM/PM
> in the
> OneCare settings.
> Note that I don't have an X64 system to test.
> -steve
>
> "Mitja Harej" <mitjaharej@xxxxxx> wrote:
> | Quote: | | | |
>>I have installed OneCare 2 90-day trial on my Vista X64 machine earlier
>>today and I must say I'm quite satisfied with the program, but I found a
>>small bug under "Settings": It is impossible (at least for me) to schedule
>>"Tune up" and "Scan" using the 0-23 format hour, despite I use this time
>>format in Vista. There is not even the "AM" or "PM" information to
>>determine
>>when exactly the task is scheduled.
>>
>>Best regards,
>>
>>MH
>>
| | | | | >
> --
> Stephen Boots
> MVP Windows Live
> Windows Live OneCare Forum Moderator
> sboots@xxxxxx | |
| | |