Thank you for your reply; Ã*ll try the 'run as administrator' later. I noticed
that the drivers are not suited for x64 yet, however they work perfectly. The
only thing is that they wont stick (this is only the case for the
remotecontrol driver, not for the tv-card drivers) I allready asked on the
Hauppauge site, and the (unofficial?) Vistax64 site) after doing some
research, but they can't answer my question. All pointers given had already
been tried by me.
Do you, or anyone, know for a fact that there are remote-control drivers
pre-installed in the vista installation (the ones that are supposed to work
with the WMC-remote?) And if so, can you please give me the names of those
drivers (and locations), and also the registry entrys that belong to them? I
wouldnt know where else to go look for those... Can't find anything on the
internet about it; Thanks again
"SG" wrote:
Quote:
> Hi,
>
> Looking at their support site I would suggest following the install
> instructions on this download page.
> http://www.hauppauge.co.uk/pages/sup...w_xpvista.html
>
> With one exception on their instructions when they suggest "Once done,
> double click on the link to the install application on your desktop" I would
> right click that icon and select "Run as administrator".
>
> Also note on that page it states "Support for Windows XP/Vista" however, the
> way I'm reading those instructions the drivers are not certified for Vista
> or else you would not have to click install this driver software anyway, but
> I could be wrong. If you look at the FAQ page under "Operating Systems Help"
> Vista is not listed and the Vista 64 is definitely no where to be found.
>
> --
> All the best,
> SG
>
> Is your computer system ready for Vista?
> https://winqual.microsoft.com/hcl/
>
> "HAMMER" <HAMMER@xxxxxx> wrote in message
> news:8B452A8F-843D-4BC1-ABFF-79C05BCD519C@xxxxxx Quote:
> > Hi,
> >
> > I'll start off with the specs:
> > Q6600 @ 3.4Ghz
> > GA-P35-DQ6
> > 2x2 Gb Patriot extreme memory 800Mhz
> > Hauppauge WinTV-HVR 3000
> > Vista Ultimate x64
> >
> > Now to the problem:
> >
> > The remote control, that came with the Hauppauge TV card, works like a
> > charm
> > in WMC, except everytime i reboot, i need to reinstall it's drivers.. They
> > won't 'stick' in the registry.. Now i know the problem could be that there
> > are allready some Vista certified IR-remote drivers pre-installed in
> > vista,
> > but i don't know which ones they are. (the registry entry(s) and the
> > driver-names).
> > I'd be much grateful if someone could give me those names, and locations,
> > so
> > i can alter and/or remove those, so that they won't conflict with my own
> > remote drivers.
> >
> > thanks in advance
>
>