I guess this is not a very active newsgroup. Anyway, I found the
problem in my case. Probably not SP1 related...
I have alot of software installed and it aparently keeps adding more
and more onto the Path variable in System Properties. On the advice of
another user in another forum, I added C:\Windows\twain_32\ (and the
name of the particular folder in there my scanner uses, not the same
for other scanners). Problem solved, without so much as a reboot!
Bob
On May 11, 11:09*pm, rvgraham <gu...@xxxxxx-email.com> wrote:
| Quote: |  | |
|
> I've noticed just recently (probably since installing SP1) that my Canon
> Lide 60 has stopped working right. To be specific, the only way I can
> reach the scanner interface for advanced scanning is to launch it from
> the canon toolbox utility. Then, once the image is delivered to
> photoshop, I have to start the re-launch the scanner interface again; I
> can't get it to stay open for more pages to be scanned. It used to open
> just fine directly from Photoshop and wouldn't close until I
> deliberately dismissed it.
>
> I've checked MS knowledge base and Canon support but I see no newer
> drivers and no other reports of my specific issue. The error I get when
> trying to open the twain interface from photoshop is: "Could not open
> the twain source".
>
> Other apps, such as Microsoft Doc imaging, don't see teh scanner at
> all. I also tried downloading VueScan but that couldn't see the scanner
> either.
>
> I only scan infrequently so I'm not gonna run out and buy a new
> scanner, but when I do scan it's usually more than one page, so this is
> a pain.
>
> Thanks, Bob Graham
>
> --
> rvgraham
| |
| | |