|
 |  |  |  |  |  |  |
Welcome to Vista Forums we are your forum to discuss Windows Vista x64 and x86 systems. Whether you need help or just want to post an idea you have on Vista, this is the forum for you.
 |
| |||||||
 |
| | Thread Tools | Display Modes |
02-01-2008
| #1 (permalink) |
| Newbie Rep Power: 6  |  Tried to upgrade to 4 gig of ram, BSOD, help? Hi everyone - I am running Windows Vista Ultimate 64 bit. Today I tried to put in 2 more gig of ram (bringing the total to 4) and got a BSOD with the error "page fault in non paged area" about 5-10 seconds after windows loaded. At first I thought it might be a hardware problem, but if I take out my old ram and just leave in the new ram, it works fine, as long as there are only 2 gigs. I installed this Error message when you try to install Windows Vista on a computer that uses more than 3 GB of RAM: "STOP 0x0000000A" after the first bsod even though it refers to a different error. I also tried to slightly increase the voltage to the memory in case that was the issue. Still no luck! Any advice? Thanks for your help!! Sarah PS I can post the mini-dump if that would be useful |
My System Specs |
|
02-01-2008
| #2 (permalink) |
| Newbie Rep Power: 6 | Re: Tried to upgrade to 4 gig of ram, BSOD, help? Boot with your setup disk and run the memory diagnostic tool. |
| My System Specs |
|
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BSOD during upgrade install | Hyweee | Vista General | 4 | 10-05-2007 03:59 PM |
| BSOD on vista upgrade from xp pro | MACscr | Vista installation & setup | 14 | 08-13-2007 10:22 PM |
| BSOD on Upgrade | Packman | Vista installation & setup | 3 | 02-02-2007 07:05 PM |
| BSOD IRQ_NOT_LESS_OR_EQUAL during upgrade to Vista RC1 | =?Utf-8?B?RXJpYyBTY2htaXR6?= | Vista installation & setup | 12 | 10-19-2006 07:42 PM |
| BSOD in Beta2 to RC1 upgrade | =?Utf-8?B?U2w0eWVy?= | Vista installation & setup | 2 | 10-07-2006 10:50 AM |
Linear Mode
