Did you do a full, power-off reboot after upgrading to RC1? Also, make sure
you don't have any AV product running on the parent partition.
If all else fails, try:
1.) uninstalling the Hyper-V role
2.) Reboot as requested.
3.) go into the BIOS and verify that you have NX enabled. And that the
hardware virtualization is turned on. (This is a good time to check that you
have the latest BIOS as well. )
4.) power off.
5.) power on. Install the RC1 update if you haven't already. Reboot as
6.) Install the Hyper-V role. Reboot as requested.
Charlie. http://msmvps.com/xperts64 http://mvp.support.microsoft.com/profile/charlie.russel
"Roger Crawford" <rcrawford@xxxxxx> wrote in message
>I was mistaken on my earlier problem as it was a beta2 to RC0 updgrade but
>I got this corrected and working. Now I upgraded from RC0 to RC1 and when I
>try to start one of my VS Servers I get the error " The VS Server could not
>start because the hypervisor is not running." This was working correctly
>before I upgrade so what am I missing now? Thanks
> Roger Crawford