Vista - To heaven from BSOD STOP 0x0000001A

Hi!

RC1 works at last!

I had Build 5384 working since July.
I did not get any STOP 0x0000001A during installation.

2 weeks, I decided to install Build 5536.
So, I downloaded it and checked MD5 ans SHA1 and it was correct.
But:
from Windows XP : upgrade -> STOP 0x0000001A during installation
from Windows XP : clean install -> STOP 0x0000001A during installation
boot from DVD : clean install without formatting C: -> STOP 0x0000001A
during installation
boot from DVD : clean install after formatting C: -> STOP 0x0000001A
during installation

I tried MEMTEST and memory was OK.

So, I was not able to install Build 5536.

This week, I decided to install RC1.

So, I downloaded it and checked MD5 ans SHA1 and it was correct.
But:
from Windows XP : upgrade -> STOP 0x0000001A during installation
from Windows XP : clean install -> STOP 0x0000001A during installation
boot from DVD : clean install without formatting C: -> STOP 0x0000001A
during installation
boot from DVD : clean install after formatting C: -> STOP 0x0000001A
during installation

I downloaded a second time and same results.

I downloaded a third time:

from Windows XP : upgrade -> STOP 0x0000001A during installation
from Windows XP : clean install -> STOP 0x0000001A during installation
boot from DVD : clean install without formatting C: -> STOP 0x0000001A
during installation
boot from DVD : clean install after formatting C: -> success ! ! ! !

To have success, I had to download RC1 3 times ! ! ! !
By the way, each time, I burned at the lowest speed (2x).

So, RC1 starts well.
But, each 5 minutes, I get STOP 0x0000001A.
And, in "Problems and solutions", RC1 reports it is : STOP 0x000000EA
THREAD_STUCK_IN_DEVICE_DRIVER (Q293078).
It is concerning the Nvidia graphic driver (7900GTX).
And, I was not able to set to off the acceleration as said in the problem
resolution.

So, I downloaded and installed the RC1 Nvidia driver coming from
www.nvidia.com.

Now, everything works well at last.
I like a lot RC1. It is very fast.
But, USB does not work; I had the same problem with Build 5384.

Bonne journée! Roger

Hi!

This morning, just after I started RC1, I get STOP 0x0000001A again.
Now, I get STOP 0x0000001A each 5 minutes.
So, I give up.

Have a nice day! Roger

That STOP error is usually related to Memory Management. Bad RAM. Can you
try other RAM modules?

--
Jane, not plain 64 bit enabled
Batteries not included. Braincell on vacation :-)
"rogerlebo" <a@hotmail.com> wrote in message
news:u$4t8e$0GHA.4972@TK2MSFTNGP03.phx.gbl...
> Hi!
>
> This morning, just after I started RC1, I get STOP 0x0000001A again.
> Now, I get STOP 0x0000001A each 5 minutes.
> So, I give up.
>
> Have a nice day! Roger
>