Vista - Windows Easy Transfer - program crashes during transfer

I am attempting to transfer files & settings using the Belkin Easy
Transfer cable from an XP computer to a Vista computer.

All starts well by showing that the two computers are connected. But after
finding the files and settings and providing the amount of data to be
transferred, it starts gathering information but then shows a flashing
disconnection icon in the upper right of both computers' transfer windows
and freezes.

This happens at a different place each time, but early in the procedure
(after about 10 minutes). Would anyone have any advice? I have done
everything by the book, as far as I'm aware. Many thanks.

Ian

--

I think I remember that the Belkin cable uses USB. That behavior is very
suggestive of a "Power Management" tab setting on the USB device properties
pages. Uncheck the option to allow the device to turn off.

--
click the Ratings button. Voting helps the web interface.
http://www.microsoft.com/wn3/locales...help_en-us.htm see ''rate a post''
Mark L. Ferguson

"Ian F." <wowfabgroovy@xxxxxx> wrote in message
news:6bl45uF3chvdiU1@xxxxxx

"Mark L. Ferguson" <MarkLFerguson@xxxxxx> wrote in
message news:eS$XKRxzIHA.5716@xxxxxx
It does, yes.
I have set the power management settings on the Vista computer to never
shut down. Is that what you mean or is there something else I should be
attending to?

Thanks,

Ian

Click start, and type: devmgmt.msc
Doubleclick all the USB devices for their Properties pages, and look at all
the "Power Management" tabs for checkboxes to uncheck.

--
click the Ratings button. Voting helps the web interface.
http://www.microsoft.com/wn3/locales...help_en-us.htm see ''rate a post''
Mark L. Ferguson

"Ian F." <wowfabgroovy@xxxxxx> wrote in message
news:6bl5b1F3cq5tfU1@xxxxxx

"Mark L. Ferguson" <MarkLFerguson@xxxxxx> wrote in
message news:eJK85hxzIHA.4004@xxxxxx
Mark, would that be on the Vista computer, the XP computer or both?

Ian

Both have the setting, and there is no way to tell which is doing it.

--
click the Ratings button. Voting helps the web interface.
http://www.microsoft.com/wn3/locales...help_en-us.htm see ''rate a post''
Mark L. Ferguson

"Ian F." <wowfabgroovy@xxxxxx> wrote in message
news:6bl7joF3cmfdpU1@xxxxxx

"Mark L. Ferguson" <MarkLFerguson@xxxxxx> wrote in
message news:ugo7C0xzIHA.1236@xxxxxx
Ok - I'll take a look at them both later and report back. Many thanks for
the input.

Ian

"Mark L. Ferguson" <MarkLFerguson@xxxxxx> wrote in
message news:eJK85hxzIHA.4004@xxxxxx
Tried this, Mark, and unchecked one box that was checked but to no avail.

Ian