Thanks for the rapid response! Unfortunately, I do not understand on how
you were able to select 480 monitor support.
Would it be possible for you to give me some more details on how to
accomplish this? I apoligize in advance for not knowing these feature.
"Chas Smith" wrote:
> I had the same problem. Rebooted and selected to use 480 monitor support.
> This gave me the display and I just reset the graphic card back to my normal
> settings once the desktop was shown. Hope this helps.
> "Beta Tester" <BetaTester@discussions.microsoft.com> wrote in message
> > Clean install of Vista 64 Bit RC-1, and experience problems at the very
> > end
> > of the install. All files are loaded and no issues reported until the
> > end.
> > The screen just turns blank.
> > Reboot machine, and it says Windows did not load correctly and do you want
> > to start in Safe Mode
> > The screen displays the error:
> > Out of Range 36.3Khz /34Hz
> > At this point the screen remains dark. If you perform the repair from the
> > install DVD, it reports it cannot resolve this issue.
> > System
> > Intel 945PSN
> > Intel Pentium D 2.8
> > Raid 0 - Raptors - 74Gig with Siig SC-SA0012-S1 PCI SATA Controller Card
> > ATI X1900 XTX
> > Sony 19" - SDM-HS95P/B - XBrite
> > Loaded the 64 Bit driver for the Siig Controller Card. Systems works fine
> > with Win XP 64 Bit version, however, when attemping to load Vista RC-1
> > experience the Out of Range Error.
> > Please advise,
> > Chad