Thanks all, I did do an upgrade from XP to RC1, and I did install then using
XP compatibility mode by mistake.
I just couldn't turn off compatibility mode, so I just went back to a
restore point before I installed the drivers and then I was able to
install then all over again, and now everything is fine. Darn, I keep
forgetting about system restore
"JW" <email@example.com> wrote in message
> Did you inadvertanly try to install them using XP compatibility mode?
> "Kirk" <firstname.lastname@example.org> wrote in message
>> Did you do an upgrade to RC1 or a new install? I was able to install
>> 96.33 with no problems with a clean install.
>> "Marc" <email@example.com> wrote in message
>>> When I run 96.33_forceware_winvista_x86_international.exe on Vista RC1
>>> (32 bit, build
>>> 5600) I get the following error.
>>> Setup detected that the operating system in use is not Windows Vista.
>>> This setup program and its associated drivers are designed to run only
>>> on Windows Visa.
>>> The installation will be terminated.
>>> Why does the 96.33 install program think I am not running under Windows
>>> Any help would be appreciated