Vista Tutorial - Logitech QuickCam communicate not detected

Hi, I have download the updated driver from logitech for the Quickcam Communicate. I start the installation and at the "Plug-in your camera" it does not detect the camera. But When i plug it Vista detects the camera but not the drivers.


Ive checked other posts but nobody found a better answer than "get another one".

Try this (it is my trick)
1. Download QuickCam 8.4.8 with driver for WinXP.
2. Install WinRAR if not already installed yet.
3. Open the setup installer qc848enu.exe and unpack its contents to a
folder. Alternatively, right click on qc848enu.exe and select
“Extract to qc848enu\” option. (do not plug in the logitech
quickcam to a USB port)
4. Open the unpacked folder of the qc848enu.exe setup
5. Open the setup in XP compatible mode and install it, when the
install end your system should be reboot.
6. after your system reboot
7. where it says "Please plug in your camera to the USB port" plug in
your cam to a USB port. (and wait a few seconds), your system should
appear "device driver software insalled successfully.
8. click next setup your cam ....... finish


--
zbouzouz
------------------------------------------------------------------------
zbouzouz's Profile: http://forums.techarena.in/member.php?userid=32060
View this thread: http://forums.techarena.in/showthread.php?t=746813

http://forums.techarena.in

your Quickcam is not compabile with vista only the stx model works

"zbouzouz" <zbouzouz.2xrhbg@xxxxxx> wrote in message
news:zbouzouz.2xrhbg@xxxxxx