![]() |
![]() | ![]() | ![]() | ![]() | ![]() | ![]() | ![]() |
| Welcome to Windows Vista Forums. Our forum is dedicated to helping you find solutions with any problems, errors or issues you are experiencing with Windows Vista. The Vista forum also covers news and updates and has an extensive Windows Vista tutorial section that covers a wide range of tips and tricks. |
| |||||||
![]() |
| |
| | #1 (permalink) |
| | RAID disk size difference I recently set up a RAID 10 on my system, using four 500GB HDD's. It went well, and the system sees it as a single 1TB drive, but windows Vista sees it as a single 500GB drive. When I go into the device manager and look at the RAID drive, windows sees it as a 1TB drive. Is there a way to get windows explorer to see the drive for its true size, 1TB? I am afraid it will not let me write past the 500GB's it thinks exists. |
My System Specs![]() |
| | #2 (permalink) |
| | Re: RAID disk size difference Were, in windows is it seen as 500gb? Is this done via an onboard controler or an extension card controller? & whose controler? "Jason" <Jason@xxxxxx> wrote in message news:8937C878-14B0-428C-845E-5851186D9063@xxxxxx Quote: >I recently set up a RAID 10 on my system, using four 500GB HDD's. It went > well, and the system sees it as a single 1TB drive, but windows Vista sees > it > as a single 500GB drive. When I go into the device manager and look at > the > RAID drive, windows sees it as a 1TB drive. Is there a way to get windows > explorer to see the drive for its true size, 1TB? I am afraid it will not > let me write past the 500GB's it thinks exists. |
My System Specs![]() |
![]() |
| Thread Tools | |
| |
Similar Threads | ||||
| Thread | Forum | |||
| Best stripe size for RAID 0 to install Vista on? | Vista General | |||
| Raid 5 with Vista Ultimate x64 on non Raid drive... No boot disk detected! | Vista hardware & devices | |||
| Can I recover from a failed Raid 1 disk? | Vista General | |||
| Delete or Format Hard Disk - What's the difference ? | Vista performance & maintenance | |||
| Activation after upgrading Disk to SATA and RAID INCH6R | Vista installation & setup | |||