Strange bootup

[Angustevo]

I've had this problem several times now on bootup.

It boots on the F2 setup screen does several seconds of the loading bar, then my screen says 'no signal' and it goes back to the F2 setup screen and freezes.
Then I have to turn of my computer by holding down the power button and start it again the second time where it boots fine.

Any ideas how to fix this?

 

[yvesj]

i did had the no signal .all i did is turn my power supply off and on .
and about that booting problem the same thing happen to me .
i had to replace my hard drive .
so i did replace every thing in my pc .the only thing i did not change is the mobo .

 

[Angustevo]

Do you only have to replace hard drive?

 

[stoneys-nutz]

Hello Angustevo,
Before you replace anything try this.
Open a command prompt as administrator and type sfc/scannow press enter and let it scan, if it picks up any errors, scan again, until it is clear.
This will check your file system for errors.
Also, go to your HDD makers site and download their diagnostic software and test your HDD.
Give this a try and post your results, good luck.

 

[Angustevo]

The command prompt scan says that it did not find any integrity violations, the HDD scan unfortunately won't work because Hitachi haven't updated it and it requires a floppy disk, I don't have a floppy disk drive...

 

[stoneys-nutz]

Try here, you can put it onto a DVD/CD disk.

Support - Downloads and Utilities