Tristicus
New Member
Well, I just got 4gb of RAM (4x1gb) from Silicon Assets. Coming from 1gb (512mbx2), which was high density. The new stuff is low latency (4-4-4-12), and low density, and double sided. Well, I installed them in Vista Ultimate x64, and only 2814 show up.
I go in the BIOS, and everything shows as 4gb, the PCI-E is limited to 512mb (because thats how much it takes iteself), and everything was set.
Well, in CPU-Z it also tells me I have 4gb of RAM.
When I used the MEM-TEST LiveCD, it said I had 2815 again, same as Vista.
I removed all the RAM and tested them one by one, and all showed up in the Bios correctly. I then put in 3 sticks so they aren't in dual and that only 3gb is there, and the same: 2815 even after scanning and everything.
I am completely lost on what to do.......
Specs:
Newegg.com - Foxconn 915A01-P-8EKRS2 LGA 775 Intel 915P ATX Intel Motherboard - Retail
4gb of RAM (Avant it says on the stick).
Ati Radeon x1650 Pro 512mb
P4 3.4ghz with HT Technology
500gb SATA HDD (Maxtor)
DVD-+RW Drive (Samsung)
680W PSU
I go in the BIOS, and everything shows as 4gb, the PCI-E is limited to 512mb (because thats how much it takes iteself), and everything was set.
Well, in CPU-Z it also tells me I have 4gb of RAM.
When I used the MEM-TEST LiveCD, it said I had 2815 again, same as Vista.
I removed all the RAM and tested them one by one, and all showed up in the Bios correctly. I then put in 3 sticks so they aren't in dual and that only 3gb is there, and the same: 2815 even after scanning and everything.
I am completely lost on what to do.......
Specs:
Newegg.com - Foxconn 915A01-P-8EKRS2 LGA 775 Intel 915P ATX Intel Motherboard - Retail
4gb of RAM (Avant it says on the stick).
Ati Radeon x1650 Pro 512mb
P4 3.4ghz with HT Technology
500gb SATA HDD (Maxtor)
DVD-+RW Drive (Samsung)
680W PSU