When I click on System Restore to do a manual restore it says it's turned off. I don't know how to turn it back on either. Also when I uncheck the Read Only box in the System Volume Information, it doesn't stick. It immediately comes right back. I feel that if I could get this box unchecked I'd be fine.
When I click on System Restore or type in rstrui.exe I get a windows that pops up and says that System Protection is turned off and then when I click on Open System Protection at the bottom the 0x80070005 error comes up. Also where it says Available disks, it says searching.. When I click OK, it says it cannot rescan the disks for the following reason: Access is denied. And yes I'm logged in as Admin....not Admin but I have Admin authority. What gives?? By any chance would Nero Back Up cause this? This is a fresh install of Vista HP x64 and I have a few programs installed but not much. I have 3 HDD's. A 500GB WD SATA, a 250GB Seagate SATA and a 80GB IDE drives. My C: drive is my 500GB SATA drive. Any help would be greatly appreciated!!! Oh and I had this problem before SP1 was installed too.
Thanks in advance!
When I click on System Restore or type in rstrui.exe I get a windows that pops up and says that System Protection is turned off and then when I click on Open System Protection at the bottom the 0x80070005 error comes up. Also where it says Available disks, it says searching.. When I click OK, it says it cannot rescan the disks for the following reason: Access is denied. And yes I'm logged in as Admin....not Admin but I have Admin authority. What gives?? By any chance would Nero Back Up cause this? This is a fresh install of Vista HP x64 and I have a few programs installed but not much. I have 3 HDD's. A 500GB WD SATA, a 250GB Seagate SATA and a 80GB IDE drives. My C: drive is my 500GB SATA drive. Any help would be greatly appreciated!!! Oh and I had this problem before SP1 was installed too.
Thanks in advance!